!
C.A.S. operating instructions
Page 8
2.1 Using the GSM/GPS Combimodule (optional)
Activating by SMS:
Send an SMS with
“arm”
to the number for the GSM module. After receiv-
ing the SMS, the system acknowledges the process with a single flash from
all 4 LEDs and a status message by SMS.
Deactivating by SMS:
Send an SMS with
“disarm”
to the number for the GSM module.
After receiving the SMS, the system acknowledges the process with
a single flash from all 4 LEDs and a status message by SMS.
Activating by phone call:
(only possible when the program selector switch is in the appropriate position)
Dial the number of the GSM module. The module ends the call after
a few seconds.
The system acknowledges the process with a status message by SMS.
Deactivating by phone call:
(only possible when the program selector switch is in the appropriate position)
Dial the number of the GSM module. The module ends the call after
a few seconds before it costs anything.
The system acknowledges the process with a status message by SMS.
Requesting status message by SMS:
Send an SMS with
“status”
to the number for the GSM module.
After receiving the SMS, the system sends back a status message.
Requesting status message by phone call:
(only possible when the program selector switch is in the appropriate position)
Dial the number of the GSM module. The module ends the call after
a few seconds and sends a status message.
When you receive a theft message, this is initially a so-called “quiet alarm”
where neither siren nor LEDs are activated so as not to attract the attention
of the culprit to the alarm system. Otherwise he may destroy it and make it
impossible to pursue the vehicle.
However, the alarm can be activated manually as described below in order
to bring it to the attention of the police car if one is pursuing the vehicle.
Activating alarm by SMS:
Send an SMS with “alarm on” to the number for the GSM module.
The siren and LEDs are switched on immediately after the SMS is received.
