1.8 Programming the target phone numbers
Once the SIM card has been inserted and locked in place the power supply
can be connected. The status LED will not flash red briefly and then will flash
yellow / green.
Now the programming SMS described below can be sent to the number for the
GSM-pro. If the SMS was received and the numbers were saved the status LED
flashes green and a status SMS is sent to the sender of the programming SMS.
GSM-pro is now ready for operation.
Target phone numbers are the phone numbers to be alerted in case
of an alarm. Up to 10 numbers can be saved.
There are different types of target phone numbers:
Master number:
Is the phone number at the top of the list when
the target phone numbers are saved. This num-
ber can program new target phone numbers
at any time, without access to the operating
mode switch.
Authorized numbers:
These are target phone numbers that have the
authorization to control the outputs of GSM-pro
via SMS, to arm and disarm the alarm system
via SMS and to request status reports.
Non-authorized numbers:
These target phone numbers have no access
to the system functions. They only receive alerts.
Smartphone numbers:
These can be master numbers, authorized
numbers or non-authorized numbers that were
provided with an “s” during programming and,
if a GPS receiver is connected, can receive the
vehicle position as a link that can be displayed
as a map with any standard smartphone.
Table: query codes
The query codes used for pre-paid cards can be found in the following table
or in the information brochure for your pre-paid card.
Provider
Query code
Provider
Query code
e-plus
*100#
Simyo
*100#
O2
*101#
Tchibo
*101#
T-Mobile
*100#
Swisscom
*130#
Vodafone
*100#
Information provided without warranty.
Changes by the provider are possible.
GSM-pro
manual Page
7
Summary of Contents for GSM-pro
Page 18: ...Handbuch GSM pro Seite 16 Notizen...
Page 35: ...Notes GSM pro manual Page 16...
