Assembling the rack
CAUTION!
Danger of cuts on hands and fingers
When connecting the parts, take care for sharp edges on the metal pipes, screws etc.
1
Align the mounting brackets for the connecting pipe and the side arms of the rack in terms of height and desired
playing position. Insert the connecting pipe and the sides arms into the brackets and then tighten all mounting
screws.
2
Attach the two lateral support pipes of the rack in the provided mounting brackets. Make sure that the ends of
the support pipes are lying on the floor. Then tighten the mounting screws.
3
Position the mounting brackets for each pad. Then tighten the mounting screws.
Turn the angle pieces in the right position for mounting the pads. Then tighten the mounting screws.
4
Put the brackets for Crash, Ride and Hi-hat pad into the provided fastening clamps at the rack. Attach the brackets
using the mounting screws at the desired height.
5
Loosen the locating screws at the joints of the brackets and turn the brackets into the desired playing positions.
Then retighten the locating screws firmly.
Assembly
MPS-425
7
