4
Mounting the pads
The pads are all individually packed in the second package. The matching cables are also included.
In all the pads, electronic drums are integrated on one side and acoustic ones on the other side. By means of a variable pad
holding system, you can turn each shell and play the drum set as an acoustic or an electronic one.
Bass drum pad
Scope of supply includes:
n
Pad
n
One short and two long tubes
n
Foot plate
n
Two rack connection clips
The bass drum has a total of three seats for rack tubes. Fasten the short tube on one side in the foot plate using the small square-
head screw and on the other in the centre hole in the shell.
Insert the two longer rods in the two adjacent seats. Fasten the connecting clips on the ends of the rods.
The screws on both ends of the clips are of different lengths. Fasten the clips such that the ends of the clips with the shorter screws
are located on the horizontal tubes to the bass drum. Otherwise, the other ends of the clips do not fit onto the rack tube.
After you have assembled everything, the pad should look like this:
Now you can use the two outside connecting clips to fasten the pad on the vertical rods of the rack. If necessary, you must push
the two tubes in the bass drum further into the pad so that the clips are on a level with the rack tube.
Mounting the pads
drum set
8
