The following graphic illustrates how to integrate the unit into a DMX configuration.
Use the product (S) as the last part of the DMX chain that begins with your DMX controller (C).
Do do so, connect the output of the last device to the input of the DMX splitter.
You can connect each one DMX chain to the active DMX outputs of the device (S) (DMX
splitter), each of which can consist of a maximum of 32 DMX devices. Connect the output of
the first DMX device to the input of the second and continue this way until all devices are con‐
nected. Make sure that the output of the last DMX device in the chain is terminated by a
resistor (110 Ω,
¼
W). You can even expand the configuration of your DMX network if you are
running additional DMX splitters at the end of the DMX chains. Keep in mind that the total
number of usable DMX addresses in a ‘DMX universe’ is limited to 512.
At the direct DMX output
[DMX Thru]
you can connect another DMX chain from a maximum of
32 DMX devices. When using this output, the
[Pass Thru / Terminated]
switch must be in the
[Pass Thru]
position (not pressed). If the device itself terminates a DMX chain, the
[Pass Thru / Terminated]
switch must be in the
[Terminated]
(pressed) position. Then a termi‐
nating resistor is cut in.
DMX connections
Installation and starting up
DMX splitter
14
Summary of Contents for Stairville DMX Splitter 8 USB 3 pin
