background image

IMPORTANT SAFETY INSTRUCTIONS

For your own safety you should read this section in full first!

Intended use

This CD-/MP3 player is intended exclusively for playback of audio CDs, MP3 CDs, CD-R or CD-

RW according to this manual. By using it in any other way you face the risk of electric shock. No 

warranty claims will be granted for damage resulting from improper use!

  Risk of electrical shock!

Connect the device only to a properly wired and earthed electrical wall socket providing a mains 

• 

voltage of 230 V~/ 50 Hz.
NEVER operate the device if the power plug or power the cord is damaged.

• 

NEVER submerse the device in water. Wipe it only with a slightly damp cloth.

• 

NEVER expose the device to rain or moisture and never use it in a damp or wet environment.

• 

Do not subject the device to high temperatures, direct sunlight, severe vibrations, shocks or 

• 

tremors, or excessive dust.
Ensure that the power cord does not become wet during operation.

• 

You must NEVER open the housing of the device or try to repair it. There are no user serviceable 

• 

parts inside. Warranty will become void if you open the housing.
Do not place objects containing fluids, e.g. flower vases or beer bottles, on or near the device.

• 

Notice regarding power disconnection: 

• 

To switch the device off and to disconnect it from the power source the power plug must be 

removed from the power socket. For this reason the device should be placed in a position where a 

constant unobstructed access to the power socket is assured, thus in an emergency situation you 

are able to immediately pull out the power plug. To eliminate the risk of fire you must completely 

disconnect the power plug from the power socket after the device has been used.
Always grasp the power cord by the plug. Do not pull on the cord itself and never touch the 

• 

power cord with wet hands as this could result in a short circuit or an electrical shock. Do not 

place the device, speaker cabinets or anything else on the power cord and make sure that it does 

not become clamped. Place the power cord in a position where it can not be trod on. A damaged 

power cord can cause a fire or an electrical shock. Check the power cord from time to time. 

Should it become damaged contact our customer service centre to have it replaced.

   Risk of fire!

NEVER leave the device unattended while it is switched on.

• 

Do not place any open sources of fire, like candles, on the device.

• 

Do not operate or store the device in hot locations or near heat sources like stoves, radiators or 

• 

the like.
When a thunderstorm with the risk of lightening threatens please disconnect the device from the 

• 

mains power.

  Risk of personal injury!

Keep the power cord and device away from children. Children frequently underestimate the 

• 

dangers of electrical equipment.
Ensure a safe location for the device

• 

. The safest place to operate the device is in a 19“ rack.

Do not operate the device if it has sustained a fall or is damaged. Arrange for the device to be 

• 

checked and/or repaired by qualified technicians.

Important!

• 

 Listening to music with headphones for long periods and at high volume levels 

can lead to hearing damage!
Keep batteries well away from children. Children can put batteries into their mouths and swallow 

• 

them. Should a battery be swallowed, seek medical assistance IMMEDIATELY.

Summary of Contents for Swissonic CDMP 1









Reviews: