Seite 33 von 48
en
4.4 Start up and operation of the cutlery polishing
machine
CAUTION!
Never install or operate the machine with a damaged power cord.
By suspicion of damage, for example an electrical fault smell, disconnect the
machine from the power circuit immediately and contact the Dörr-service personal.
Make sure the power cable is never placed near a hot surface.
Make sure the power cable is never pinched or brushed along a sharp edge or
surface.
Never expose the machine to gushes or jets of water.
1. Remove the transportation safety device.(see chapter 3.5)
2. Plug the power plug into a regulated power outlet (220/230V).
3. Activate the battery by removing the insulating strip. (see chapter 4.1)
4. Fill the complete contents of the original Dörr polishing granulate Type SG
8000 into the polishing bin of the machine.
5. Place the cutlery basket directly underneath the ejection opening of the
machine
6.
Turn on the machine by switching to “I” on the rockerswitch.
The heating process is shown on the control panel by the lit yellow LED. As
soon as the granulate has reached its required temperature, the green LED
will light up.
7. The machine is now ready for use. The wet cutlery can now be inserted into
the feed chute.
8. After use, activate the final drying process by pushing the reset button for 1
second. Afterwards shut the machine off using the main switch.
The best polishing results can be achieved by inserting wet cutlery either
straight from the dishwasher or a water bath.
Already dried water spots (lime residue) cannot be removed by the cutlery
polisher.
Insert one hand full of cutlery (approx. 10 pieces) into the feed chute every 10
seconds to get the most capacity out of the cutlery polisher.
Summary of Contents for TD 8000 FILL & GO
Page 47: ...Seite 47 von 48 12 Notes en...
