Seite 41 von 48
Contact your dishwasher service
technician to reduce the dishwashing
detergent or rinsing agent dose.
Cutlery is not
transported
out of the
machine
1.
2.
Insufficient quantity
of granulate in
Machine.
Cutlery jam may
have occurred.
1.
2.
If there is not enough granulate in
the machine the cutlery cannot be
transported correctly.
Replace the granulate with our
original Dörr polishing granulate.The
amount needed is exactly one filling.
Switch off the machine, open the top
cover and if necessary also the
cover sheet and remove the cutlery.
If this happens often, the granulate
may be swelled up. (See
troubleshooting section „Granulate
falls out of the machine“)
Poor
polishing
results
1.
2.
3.
Dry cutlery might
have been
inserted.
Heating element
malfunction.
The granulate is
too old.
1.
2.
3.
Always insert the cutlery dripping
wet.
Turn off the machine and check the
granulate temperature by hand. It
must be noticeably warm. If not the
heating element does not work
properly. Contact an authorized
service technician.
The granulate should be replaced
every 4 to 8 weeks depending on the
daily operation hours.
The machine
is too loud
1.
2.
3.
4.
Cutlery has fallen
into the machine.
Transportation
safety device was
not properly
removed.
Stainless steel
frame is vibrating.
The machine is
defect.
1.
2.
3.
4.
Remove all cutlery pieces laying by
the motor, springs and cover sheet.
Remove the transporting safety
device (see chapter3.5).
Make sure all screws are fastened, if
not tighten them.
If the steps mentioned above do not
solve the problem contact an
authorized service technician.
Machine does
not start
1.
2.
Top cover is not
closed.
Damaged Fuse.
1.
2.
Close the top cover.
en
Summary of Contents for TD 8000 FILL & GO
Page 47: ...Seite 47 von 48 12 Notes en...
