Seite
42
von
48
3.
4.
Power plug may
not be plugged in.
Machine has a
malfunction.
3.
4.
Check the fuses and have them
replaced by an authorized service
technician.
Check if the power plug is inserted
correctly.
Contact an authorized service
technician.
A cutlery jam
has occurred
inside the
machine.
1.
2.
Too much cutlery
has been placed
into the machine.
The granules have
swollen, caused
from absorbing too
much moisture.
1.
2.
Begin feeding the machine with 30-
40 cutlery pieces. Afterwards only
place a hand full of cutlery inside the
machine after the previous fed
cutlery has vanished underneath the
granules.
In case the granules have absorbed
too much moisture, it will swell
causing each corn to expand. The
filling volume will expand by
approximately 20-30%. This means
the openings for the cutlery pieces
become smaller. To avoid this
happening we strongly recommend
performing the heating up and final
drying process. Please change the
granules immediately if this is the
case. (See page 9, chapter 5.2)
The cutlery is
abnormally
intensively
scratched.
1.
The cutlery pieces
fall too deep from
the ejection chute.
1.
Please immediately make sure the
cutlery basket, in which the cutlery
pieces fall into, is placed directly
underneath the ejection chute.
All LED´s
from the
panel are
blinking
continuously
and a clear
beeping
sound is
heard
1.
The batteries
voltage is very low
1.
Replacing the battery (refer to
chapter 5.4 Replacing the battery)
en
Summary of Contents for TD 8000 FILL & GO
Page 47: ...Seite 47 von 48 12 Notes en...
