TA04864 E Page 10 of 13
9.0
MAINTENANCE
IMPORTANT:
The Automated Crimping System and tool packs should be cleaned, inspected for visible signs of
wear/damage and lubricated every (8) hours of operation.
WARNING:
TURN OFF POWER.
IMPORTANT:
For parts or service, contact the tool service center at (800) 284 - TOOL (8665).
1. Remove the Tool Packs from the Automated
Crimping System Assembly.
2. Clean Tool Packs, refer to step 9.1 above.
3. Inspect Stock Guide Assembly and Ram Tooling for
visible signs of wear/damage.
4. Replace any worn/damaged parts.
IMPORTANT:
Portions of the tooling that make
contact during the crimping process are more
prone to visual signs of wear.
INSPECTION
9.2
Recommended lubricant:
NLGI #2 Grade Lithium
Complex EP grease or equivalent.
1. Apply light coating of lubricant to each corner of the
Ram.
2. Apply a light coating of lubricant to each corner of the
Ram Guide.
3. Remove any excess lubricant and re-insert Ram into
Assembly.
LUBRICATION
9.3
Recommended Cleaning Aid:
Clean cloth or equivalent
material.
1. Remove the Ram from the Automated Crimping
System Assembly.
2. Remove the Crimp Dial from the Ram.
3. Remove the tool pack from the Automated Crimping
System Assembly.
IMPORTANT: DO NOT
use solvents when
cleaning the Automated Crimping System and
Tool Packs
CLEANING
9.1
