7
Assembly
3
Backsplash Assembly
□
To mount the backsplash (C) to the wall, apply a thin bead of silicone compound (not included) to the unpolished back side and bottom
of the backsplash (C). Position backsplash (C) as shown onto vanity top (A) and against the wall. Clean any excess silicone compound
before allowing to dry.
4
Adjustable shelf
□
Note: The adjustable shelves are pre-installed for shipping. If the shelf position is not to your liking, you will need to reposition the shelf
by following the steps below:
a.
Look under the shelf, and locate the wood screws holding the shelf to the shelf supports.
b.
Remove the wood screws from each shelf support with a Phillips screwdriver (not included).
c.
Remove the adjustable shelf from the vanity (B).
d.
Remove the shelf supports from the vanity (B) and re-position them in the desired location. Make sure you place the shelf supports
in the same level so the shelf is not tilted.
e.
Place the adjustable shelf back onto the shelf supports.
f.
Using the Phillips screwdriver, reinstall the wood screws through the shelf supports and into the shelf.
B
C
A
Silicone
