Chapter 2: WEB Configuration
Illustrations contained in this document are for representation only.
64
4. Access Control
This page allows you to make access control to the AP or connected clients by offering the MAC
Addresses of the clients.
Fig. 46 Gateway\Wireless\Access Control
Administration Web Page Access : S
elect
Allow
to permit access to Administration Web Page from
PC connected over Wifi; or choose
Deny
to prevent the clients connected over Wifi from access to
Administration Web Page.
MAC Restrict Mode :
Click
Disabled
to welcome all of the clients on the network; select
Allow
to
permit only the clients on the list to access the cable modem; or choose
Deny
to prevent the clients on
the list to access this device.
MAC Address :
Your Gateway identifies wireless PCs by their WiFi MAC Address. This address
consists of a string of 6 pairs of numbers 0-9 and letters A-F, such as 00 90 4B F0 FF 50. It is usually
printed on the WiFi card of the device (e.g. the PCMCIA card in a laptop). It can also be determined
from a Windows DOS prompt as explained below.
Enter the MAC addresses of the connected clients into the fields, and then click Apply to add them to
the list for access control.
Apply :
After proper configuration, click Apply to invoke the settings.
Connected Clients :
The information of currently connected clients will be displayed here.