13
EN
EN
www.mythomson.com
MOTOR DRIVE FOR 2-PANEL GATES - CONNECT
C - INSTALLATION
2.4. Prevention of other hazards
The body of a switch with no lock must be located in direct view of the driven part but away from moving
parts. Unless it operates with a key, it must be installed at a minimum height of 1.5m and must not be
accessible to the public.
After installation, ensure that the components of the gate do not hang above a footpath or public access
road.
3. INSTALLING THE MOTOR DRIVE
The motor drive must be installed by qualified personnel, in compliance with all the indications provided
in the “General warnings.”
Before starting installation, ensure that:
• Hazards can be minimised by following the recommendations under the Chapter “Hazard analysis.”
• The desired use has been correctly defined.
• The gate complies with the specifications provided in the Chapter “Specifications of the gate to
motorise.”
The different stages of installation must be followed in order and in compliance with the indications given.
Overview
The cables used must be appropriate for outdoor use (such as H07RN-F for example).
The cable run between the two pillars must comply with applicable standards (NFC 15-100).
The geared motor power cable must run 80cm deep with red warning mesh.
motor
photocells
motor
Inner side of the property
Flashing light
1
2
3
4
5
