53
EN
EN
www.mythomson.com
MOTOR DRIVE FOR 2-PANEL GATES - CONNECT
E - OPERATION
4.1. “Semi-automatic closing” mode
Description of operation from the closed gate
position:
To open the gate:
• Activate the complete (or partial) opening
command.
• The flashing light will flash (1 flash per second).
• 1 second later, panel M1 starts opening.
• 2.5 seconds later, panel M2 starts opening.
• Both panels open up to their opening stop.
• When both panels have reached their opening
stop, the flashing light will stop flashing and the
manoeuvre will be complete.
To close the gate:
• Activate the complete or partial opening
command.
• The flashing light will flash (1 flash per second).
• 1 second later, panel M2 starts closing.
• A few seconds later, panel M1 starts closing.
• Panel M2 reaches its closing stop.
• Some time later (2.5 seconds by default, but
this time can be adjusted), panel M1 reaches
its closing stop.
• The flashing light will stop flashing and the
manoeuvre will be complete.
At any time, you can stop the gate’s movement
by activating a command (total or partial). If you
activate the gate control again, the gate will start
in the opposite direction.
4.2. “Automatic closure” mode
Description of operation from the closed gate
position; the photocells must be operational:
• Activate the complete opening command.
• The flashing light will flash (1 flash per second).
• 1 second later, panel M1 starts opening.
• 2.5 seconds later, panel M2 starts opening.
• Both panels open up to their opening stop.
• When the two panels have reached their opening
stop, the flashing light begins to flash differently (1
flash every 1.25 seconds) and the time delay before
closing starts.
• When the time delay is over, the flashing light will
resume its normal pace (1 flash per second).
• 1 second later, panel M2 starts closing.
• A few seconds later, panel M1 starts closing.
• Panel M2 reaches its closing stop.
• Some time later (2.5 seconds by default, but this
time can be adjusted), panel M1 reaches its closing
stop.
• The flashing light will stop flashing and the
manoeuvre will be complete
.
At any time, you can stop the gate’s movement
by activating a command (total or partial). If
you activate the gate control again, the gate will
start in the opposite direction. If you activate
a command during the time delay, it will be
stopped and automatic closure will be cancelled.
4.3. “Collective” mode
Operation is identical to “automatic closure”
mode, except:
The photocells must be operational.
• You cannot stop the gate from opening,
either with the complete or partial opening
command.
• If you activate the complete opening command
during the time delay, it is reloaded with the
initial time to extend the time before automatic
closure.
• If you activate the complete opening command
during closure, the gate will stop and open
again and the time delay before automatic
closure will start.
• The partial opening command is inoperative.
