EN
10
When pressing the
STATUS
key, the name of the current programme is displayed in the lower part of the screen.
SUBTITLE FEATURE
Once you have programmed one or more
recordings, you may want to check your
programming:
- either select the line
Timer review
of the
RECORD TIMER
menu; when proceeding this
way, you can change or cancel a
programmed recording; select the
programmed recording with key
V
or
W
and
follow the indications displayed at the bottom
of the menu (should you wish to make any
change, refer to page 13 –
PROGRAMMING
OPTIONS
);
- or press the
MENU
key when the VCR is set
on standby-programming (VCR switched off).
Note: If you have programmed two recordings with overlapping times, the VCR will
indicate this problem in the menu
TIMER REVIEW
. In such a case, change your
programming accordingly (page 25).
The menu
TIMER REVIEW
consists of two
pages. To access the other page, select
Next
page
and then validate with
OK
.
3
Note
: This function is supported by any channel sending Teletext (for the satellite channels, select SA
with the
AV
key).
• Choose a VCR channel.
• Scroll the programmes one by one and with key
V
or
W
, select the telecast you wish to record.
• Press OK to validate your selection.
The menu
TIMER REVIEW
comes up (see box below).
• Press
EXIT
, your programming is completed.
• Switch the video recorder on off (TIMER mode) standby-recording.
1
• Press key GUIDE
• Wait until the
NAVICLICK
page comes up.
2
TIMER REVIEW
Note
: a great number of satellite receivers – and among them most digital models – must be left
on to ensure that your timer-programmed recordings work properly.
U-T7078PE-GB/MR-BEI/912 6/01/00 10:18 Page 10
