Connections and Setup
5
EN
Note: If one of the devices is not working, check that all the cables have been inserted properly into the
sockets which they should be connected to.
Connecting the aerial
The FM aerial (provided) should be connected to the FM aerial socket at the
back of the appliance.
Note: For FM reception, extend the aerial to its full length and install it so that you can
obtain the best possible reception.
Connecting the speakers
SPEAKERS 8
Ω
FR
FL
SR
SL
CEN
SUB
4
Ω
Six speakers are provided with the appliance (2 front, 1
centre, 2 rear, 1 subwoofer). In order to enjoy good
surround effects, all six speakers need to be connected to
the player.
One speaker wire is provided for each speaker
connection. Speaker wires are colour-coded to match the
colour-coded terminals.
Connect the speaker wire to the back of each speaker
and to the corresponding colour terminal at the back of
the appliance. Press down the tab to open the terminal
and insert the wire (1). Release the tab to lock the wire in
the terminal (2). Do the same for the centre speaker, rear
speakers and the subwoofer.
Note: When connecting the speakers, make sure the polarities
(“+” speaker wire to “+” on the player) of the speaker wires
and terminals match. If the wires are reversed, the sound will
be distorted and lack bass (“out of phase” effect). Do not
ground the output line, as this will damage the speaker.
Audio cables
(red and white)
Optical digital audio input (OPTICAL IN)
This socket offers a higher level of sound quality compared to that provided
using an analogue audio connection. Use this socket to connect your satellite
receiver to the DVD Player using an optical cable (not supplied).
AUDIO IN L (left) and AUDIO IN R (right) sockets
(AUX 1 and AUX 2)
These are analogue audio input sockets.The AUDIO L socket and cable are
white, while the AUDIO R socket and cable are red.
(1)
(2)
Optical cable
DPL933_EN 11/03/05 10:46 Page 5
