47
GB
GB
A
ppendix: troubleshooting
Symptom
Page
Remedy
The remote control does not
work?
The “ ” icon appears
on-screen?
TV or video recorder cannot
be operated with the remote
control.
Playback does not start when
the PLAY key is pressed?
Playback stops immediately
after the PLAY key is pressed?
A screen informs you that the
disc cannot be played.
A screen asks you if you want
to override the player’s rating
level or make another
programme selection.
Search forward & reverse
playback does not work?
The Video CD cannot display
a menu?
No picture or the picture
shown is not that of the DVD
player.
4
4
7
7
42-45
8-22
2
1
1
2
40-41
33
20
Remote Control
• Load the batteries and check that their polarities (+ and –) are
correctly aligned.
• Batteries are low. Replace with new ones.
• Remove batteries and hold down one or more keys for several minutes
to drain the microprocessor inside the remote to reset it. Reinstall
batteries and try remote again.
• Point the remote control to the front of the player.
• Operate the remote control within an 8 m range from the player.
• Remove any obstacles between the remote control and the red LED on
the player.
• When “ ” appears on-screen, it indicates that you have pressed the
wrong key, because:
1. The DVD does not allow it.
2. The DVD does not propose this option /e.g., angles.
3. The function is not available on that part of the disc.
4. You have requested a title or chapter number or search time that
is not available.
• Not all models can be operated with the supplied universal remote
control. Try with other brands' codes.
Playback
• Make sure that the disc (single sided) is loaded correctly with the title
label facing up.
• This player can play DVDs, Video CDs and Audio CDs only, check
that your disc corresponds to one of these formats.
• If the disc is dirty, wipe it with a soft and clean cloth.
• Condensation occurred inside the player. Leave it at room temperature
for 1 to 2 hours.
• The disc’s region No. differs from your player’s region No.
• The initial rating setting in the set-up menu prohibits playing this
DVD. Restriction level was defined in the player.
• Some DVDs have segments where search forward & reverse playback
functions do not work.
• Only a Video CD with playback control (PBC) can display a menu.
• Switch off the other video device connected to the AV2 jack of the
DVD player.
• Make sure that the input setting for the TV is in audio / video (AV)
position, e. g. AV 1, AV 2.
• Check the SCART output selection for AV 1 (video / s-video / RGB).
DTH4500-GB 7/09/00 13:34 Page 47
