EN
EN
and the
symbol are
registered trademarks of SRS Inc. The
TruSurround
TM
technology is manufactured under
license from SRS Inc.
When the player menu is displayed (in stop mode):
1.
select
Sound
using the
Navigation
keys,
2.
press
ok
to validate,
3.
select a function using the
Navigation
keys,
4.
adjust the setting using the
Navigation
keys.
13
S
ound menu
Sound Logic
Stereo
This function is designed for night-time listening to avoid disturbing your neighbours. The player
then adjusts the differences in sound levels through dynamic compression. It then becomes easier to
hear the soft sounds while the louder sounds are dampened.
• Select
Sound
then
Sound Logic
and position the function on
On
with the
ok
key.
This function enables you to configure the stereo sound outputs according to which other devices are
connected to your player. When Stereo is switched to On, the sound is played through the Scart TV
socket and the four L and R (stereo and surround) RCA sockets. If you switch Stereo to Off, the sound
is not played through the Scart TV socket and the two stereo sockets (L and R). This setting is
intended for 5.1 channels sound reproduction using an amplifier connected to your player’s six RCA
sockets (5.1 CH SURROUND).
Digital audio output
Depending on the audio device connected to the digital output (coaxial or optical), you should
parameterize your DVD drive with the help of the following instructions. Select
Digital output
,
then parameterize each of the controls (
Dolby Digital
,
DTS
), with the help of
Navigation
.
Virtual Surround (SRS
(1)
- TruSurround)
This function provides you with virtual reproduction of the multichannel sound of a Dolby or DTS
film onto the two channels of your TV or stereo amplifier. The sound effects of a 5.1 system are then
simulated.
• Select
Sound
then
Virtual Surround
and position the function on
On
with the
ok
key.
Dolby Digital
is a sound
compression technique elaborated by Dolby
Laboratories for digital audio multichannel signals.
The Dolby Digital system enables any audio
channel configuration, from a stereo sound (2
channels) up to the digital “surround” sound 5.1.
«Dolby Digital» and the double-D symbol are
trademarks of Dolby Laboratories Licensing
Corporation. Copyright 1992 Dolby Laboratories
Inc. All rights reserved.
PCM
If the device connected to the DIGITAL AUDIO
OUT sockets does not support Dolby or DTS
signals, your player will deliver PCM (Pulse Code
Modulation) signals. In that case, neither Dolby
Digital, nor DTS must be ticked.
The linear PCM is a signal recording format used
for CDs. CDs are recorded in
44.1kHz /16bits. DVDs are recorded in 48kHz / 16
bits, or even up to 96kHz / 24 bits.
The Sound menu provides you with settings so you can adapt your player to the devices
connected. It also enables you to access specific functions.
2.
4.
1.
Navigation
keys
* If the DVD disc contains an audio format of higher quality than 48kHz/16bit (maybe 96kHz/ 24bit), the player has to
convert into a format compatible with DAT or MD.
DTS
is a digital sound compression
technique developed by Digital Theater
Sound Systems for digital audio multichannel
signals.
"DTS" and "DTS Digital Out" are registered
trademarks of Digital Theater Systems inc.
3.
DIGITAL OUT
Logo registered by PHILIPS Corp.
MPEG
Multichannel
DTH460_EN 7/08/02 10:41 Page 13
