152
Kalypso Reference Manual
Section 2 — Control Panels
Master E-MEM Mode
The E-MEM subpanel operates as Master EMEM when delegated to
Pgm Pst
in the Bank Delegate subpanel. In this mode you can enable multiple
E-MEM levels for control, and the buttons listed above are active. The
Master
E-MEM indicator illuminates in this mode.
Effect Editing Controls Removed
Unlike the E-MEM subpanels on 2 and 4-M/E Main panels, there are no
dedicated effect editing buttons on the 1-M/E Main panel. For Release 11.0
you can use the Timeline menu on the Menu panel (or a connected PC
running the Kalypso Menu application) to perform effect editing functions.
Trans Rate Button
The
Trans Rate
button is retained on a 1 M/E Main panel, and is used to enter
transition rates and other durations. This button replaces the Detent button
present on the larger panels. Values are entered in seconds, frames, field,
with the default entry being frames. When entering a transition rate on the
currently delegated bank, the duration in frames is displayed in the Tran-
sition subpanel (see
Transition Rate Readout on page 155
Recall and Run Modifier Buttons
The Recall and Run Modifier controls on the left operate the same as 4- and
2-M/E Main panels. The
Auto Recall
and
Auto-Run
buttons are active in
Master E-MEM mode. Only the
Auto Run
button is active in individual
E-MEM mode.
Run Control Buttons
On the 1-M/E Main panel Effect Run controls are located on the right side
of the E-MEM subpanel, and there is no Effect Run lever arm. These con-
trols apply to the M/Es the E -MEM subpanel is currently delegated to con-
trol. All these buttons are active in Master E-MEM mode. Only the
Run
button is active in individual E-MEM mode.
Keypad Numeric Entry
Delegation of the keypad for numeric entry (Bank selection, Trans Rate,
Effects Dissolve, Sequence), applies to the M/E the E-MEM subpanel is del-
egated to, not just to master E-MEM.
