124
Kalypso Reference Manual
Section 2 — Control Panels
Inactive Controls
The
Partial KF
,
Mark
,
Mark Block
, and
Clear Marks
buttons are inactive in Release
11.0.
Learn Modify
Each E-MEM register contains header information, along with keyframe
data. This header information applies to the entire effect and is not keyfra-
mable. Register header information includes:
•
E-MEM enable group button selections (for Auto Recall)
•
Effect Dissolve state (on or off)
•
Effect Dissolve rate (seconds, frames, field)
•
DPM effect number
When an effect is edited in the standard manner
(Insert
,
Mod
,
Mod All
), only
keyframe data is affected. The header information does not change. In a
standard
Learn
operation, all existing keyframe data is overwritten with a
single keyframe, and new header information is saved.
You can use Learn Modify to update E-MEM register header information
without changing keyframe data. To use this feature, select the state of the
desired header information, then press
Learn
,
Mod
. Examples are presented
below:
To change the enable groups associated with Auto Recall:
Press
Auto Recall
so it is on, select the desired Master E-MEM Enable buttons
for the desired groups of levels, then press
Learn
,
Mod
.
To change the Effect Dissolve rate of the current effect:
Press
Effect Dis
so it is on, then press
Trans Rate
, (type seconds, frames, fields),
Enter
,
Learn
,
Mod
.
To change DPM effect number:
Select a different effect on the external DPM, then press
Learn
,
Mod
.
