Kalypso Reference Manual
347
M/E Menus
Color Corrector Menu
RGB Color Correction is a software enabled option available on Kalypso
HD and Duo systems. This feature converts the video signal on a particular
video bus from color difference format to RGB (red, green, blue) color com-
ponent format, applies separate offset, gain, and gamma to each RGB com-
ponent, then converts from RGB back to color difference (Y, Cb, Cr) format.
The color correction is applied on a source by source basis. The parameters
are applied on the basis of a source and bus intersection and stored as part
of source memory. A different source on the same bus or the same source
on a different bus can have different color correction.
The Color Corrector menu is used to adjust RGB color on a selected bus and
source. Touch
M/E
,
Color Corrector
to access the menu (
).
Figure 239. Color Corrector Menu
The M/E pane button group selects the M/E. The Bus data box group
selects the bus layer within the M/E. The data boxes for the Bus delegation
contain
Red
,
Green
,
Blue
, or
---
. A color component in the data box indicates
that color correction is being applied to the component(s). For components
not enabled, the
---
is shown as a place holder.
The Source pane is a non-editable text box that shows the Name of the
source currently selected on the crosspoints of the M/E and bus delegated
above. It is to this source and only on the delegated M/E and Bus that the
color correction will be applied.
