10
Use
ShowView is a registered trademark of Gemstar Development Corporation.
The ShowView system is manufactured under licence from Gemstar Development Corporation.
ShowView and the satellite demodulator
J
If you use the ShowView codes to record a programme broadcast by satellite, the ShowView
programmer can ask you to confirm the channel number (Pr99 / AV1 / AV2).
• Connection by the aerial cable - During the automatic channel set-up, the video recorder
has assigned channel number 99 to the satellite receiver connected by the aerial socket. Select
this number to view the pictures of the satellite channels. Should these pictures not come up on
the screen, refer to the chapter “New or encoded channel” (page 5).
• Connection by the AUDIO/VIDEO 1 or 2 socket - If your satellite receiver is connected to
the video recorder by the audio video socket, do not choose a number but select the
AV1 or AV2 socket.
P
rogramming a recording
J
You can programme a recording with the ShowView codes indicated in your TV magazine or by
means of timer programming if you don’t know these codes. Your video recorder has 4 programming
memories. Thus, you’ll be able to programme 4 recording over a 1-year period.
With the ShowView codes
1
Call up the
SHOWVIEW
menu with key PROG. (
5
).
2
Enter the code of the programme with the number keys (
19
).
3
Confirm with OK (
10
).
ð
The
TIMER
menu comes up.
ð
You may complete your programming by choosing daily or weekly repetition, double
length or VPS- or PDC-signal triggered recording.
J
When programming for the first time, the cursor positions itself on PR; confirm or enter the
desired programme number.
4
Leave the menu with EXIT (
14
).
5
Switch the video recorder on standby with key
B
B
(
3
).
ð
The indication
, appears on the display of your video recorder to tell you that your
programming was successful.
Load a tape and position it to the desired section with keys REW., FWD., STOP, PLAY
(
24
,
26
,
27
,
25
).
Storage of the programme numbers with the ShowView feature
J
To spare yourself from having to enter the corresponding programme number in addition to the
ShowView code, the video recorder automatically stores the numbers of the channels you have
chosen to record with the ShowView feature.
This is to say that on your FIRST selection of a channel to programme a recording with the
ShowView feature, the video recorder will prompt you to confirm or enter the channel number. When
programming your next ShowView recording, the video recorder will automatically identify the
channel concerned.
r9-1GB01 8/02/00 18:49 Page 10
