GB
4
When you have retrieved the code of your set, jot it down so that you can use it whenever
needed.
After battery replacement, you’ll have to programme the remote control again.
- For a TV set or satellite receiver: press for instance number key 2 to switch over to another channel or to switch
the set on, in case it is off.
- Video recorder: load a tape and then press PLAY.
- DVD player: load a DVD and then press PLAY.
Try other remote control keys to find out the range of functions you can control. If you think that not all of the keys
are active, try the programming Method B or C.
4 – How to retrieve a programmed code
5 – Check of the programming
6 – The NAVI
LIGHT system
It may be useful to retrieve the code programmed in the remote control.
1. Set the selector (26) on the type of set concerned (TV, VCR or SAT).
2. Hold down the key SET UP (17) until the red indicator lamp (13) remains lit.
3. Press SET UP (17) again briefly. The red indicator lamp flashes once.
4. Press the number keys (0 to 9) in ascending order until the red indicator lamp
(13) flashes once.
5. The digit which made the red indicator lamp (13) flash, is the first number of the
3-digit code. Please note it down below.
6. Repeat step 4 to find out the two other numbers of the code.
7. When the third number is found, the red indicator lamp (13) goes off.
The THOMSON NAVILIGHT system allows you easy access to the settings of your
television (TV) or video recorder (VCR) including this feature.
1. Switch on the set you want to control.
2. Set the selector (26) on the type of set concerned (TV, VCR or SAT). In the VCR
position, make sure that the AV mode is activated for the TV set (the SCART socket
must be selected).
3. Press key MENU (9) once.
4. Navigate through the setting menus with the keys up, down, left, right
(7 and 8).
5. Validate with OK (20).
6. To leave the menus, press key EXIT (21) once.
TV CODE
VCR CODE
SAT CODE
ROC 330 7/05/99 23:08 Page 4
