4
When you have retrieved the code of your product, make note of it; after battery
replacement, you may have to programme the remote control again.
4 – How to retrieve a programmed code
5 – Check the programming
You may want to retrieve the code programmed in the remote control.
1. Hold down the S key (17) until the red indicator lamp (1) remains lit (the indicator
light remains on for a few seconds to give you the time to proceed with the
following steps. The indicator lamp flashes when this time is almost up, and then
goes off).
2. Press the product key (2) that corresponds to the type of product you want to
control:
TV
: television set, VCR: video recorder, SAT: satellite receiver,
DVD
: DVD player, AUX: other product.
3. Press S (17) again briefly. The red indicator lamp flashes once.
4. Press the number keys (0 to 9) in ascending order until the red indicator lamp (1)
flashes once.
5. The digit which made the red indicator lamp (1) flash, is the first number of the 3-
digit code. Please make note of it.
6. Repeat step 4 to find out the two other numbers of the code.
7. When the third number is found, the red indicator lamp (1) goes off.
TV CODE
VCR CODE
SAT CODE
AUX CODE
DVD CODE
- For a television or a satellite receiver: turn on and off, then try to change channels using PROG+/1 (16) or
a digit key (9).
- Video recorder: load a tape and then press PLAY (
B
) (13).
- DVD player: load a DVD and then press PLAY (
B
) (13).
Try other remote control keys to find out which functions you can control. If you think that not all of the keys are
active, try the programming Method B or C.
Method E – Programming for control of a COMBO (TV-VCR)
To set up the remote control to control a COMBO you first programme the television and
then the video recorder subset.
Before you start programming, you must find the subcode or code of the combo to be
controlled (television or video recorder).
Refer to the list supplied with this user manual (see page subcodes or codes).
1. Turn on the COMBO you want to control.
2. Hold down the S key (17) until the red indicator lamp (1) remains lit (the indicator light
remains on for a few seconds to give you the time to proceed with the following steps.
The indicator lamp flashes when this time is almost up, and then goes off).
3. Press the TV key (2), then follow one of the programming methods (A, B, C or D)
described earlier.
4. Hold down the S key (17) until the red indicator lamp (1) remains lit (the indicator light
remains on for a few seconds to give you the time to proceed with the following steps.
The indicator lamp flashes when this time is almost up, and then goes off).
5. Press the VCR key (2), then follow one of the programming methods (A, B, C
or D) described earlier.
EN
01-ROC 56 GB 24/02/04 14:37 Page 4
