Note
• Do not move the remote controls during the
learning procedure.
• Ensure that the room is not lit by fluorescents
tubes or low energy consumption lamps since
such light sources could interfere with the
copying.
• The 2 remote controls must be at least
1 meter away from any light source.
• During learning mode, if no key is selected for
more than 30 seconds, the learning mode will
exit automatically or
if no other remote signal is received.
• Each function key will hold only one
command. A new command to be learned will
automatically replace the previous one.
• It is not possible to learn any new functions to
the TV and STB key.
7.2 ENTER LEARN MODE
1. Press and hold the [MUTE] and [VOL+] keys for
approx. 3 seconds until the LED will be lit.
2. The Universal Remote Control is now ready to
learn new commands.
7.3 LEARNING OF KEYS
1. Press and release the desired key on the
original remote control which you want the
command to be learned. The LED at your
Universal Remote Control will flash to confirm
that the information has been received.
2. Then press and release the target key on the
Universal Remote Control you want learned.
3. If the LED flashes 3 times and then remain on,
the command has been learned successfully.
4. Repeat these steps to learn other key functions.
5. Please press any key to save the code and exit
learning mode.
Note
While replacing the batteries, the remote control will
keep the functions of the learned keys.
7.4 CLEARING OF LEARNED KEYS
7.4.1 CLEARING OF ONE LEARNED KEY
1. Press and hold [MUTE] and [VOL-] keys for
3 seconds until the LED will be lit.
2. Press and release the desired key at the
Universal Remote Control which you want to
clear the learned command. If the LED flashes
3 times, the learned command has been
cleared successfully.
7.4.2 CLEARING OF ALL LEARNED KEYS
1. Press and hold the [MUTE] and [POWER] keys
for approx. 6s until the LED indicator flash four
times, then means the command has been
cleared successfully.
8. Maintenance
• Do not mix new and used batteries for
powering the Universal Remote Control, as old
batteries tend to leak and may cause power
drain.
• Do not use corrosive or abrasive cleaners on
your Universal Remote Control.
• Keep the Universal Remote Control dust free by
wiping it with a soft, dry cloth.
9. Troubleshooting
Q. My Universal Remote Control does not work at all!
A. Check your TV/STB device. If the device’s main
switch is turned off, your URC cannot operate your
device.
A. Check whether your batteries are inserted properly
and are in the c/- position.
A. Check whether you have pressed the correspondi-
ng device mode key for your device.
A. If the batteries are low, replace the batteries.
5
Summary of Contents for ROCZ107
