Push Button Functions
Power Push Button
Press the button once to start operation with the default low fan speed. Press it
again to stop operation.
Fan Speed Push Button
Press to set the desired fan speed. It can be adjusted between high speed and
low speed.
OPERATION
1.
Turn the unit On:
When the unit is plugged in, a buzzer will beep and the unit will start to run with a low fan speed.
Press
button to start operation.
2.
Stop operation
Press the POWER button
to stop dehumidification.
Never stop the unit by unplugging the supply cord.
DRAINING THE COLLECTED WATER
When the drainage tank is full, the tank full indicator light will turn on, the operation will stop automatically
and the buzzer will beep 15 times to alert the user that the water needs to be emptied from the drainage tank.
Emptying the Drainage Tank
1.
Hold the top and bottom center of the water tank with both hands and pull it out gently.
2.
Discard the collected water
NOTE
1.
DO not remove the float from the water tank. The water full sensor will no longer be
able to detect the water level correctly without the float and water may leak from the
water tank.
2.
If the drainage tank is dirty, wash it with cold or lukewarm water. Do not use detergent,
scouring pads, chemically treated dust cloths, gasoline, benzene, thinner, or other
solvents, as these can scratch and damage the tank and cause water leakage
3.
When replacing the drainage tank, press the tank firmly into place with both hands. If the tank is not
positioned properly, the “TANK FULL” sensor will be activated, and the dehumidifier will not operate.
