InsTruCTIon
P3
English
overloading
- Never overload wall outlets, extension cords, power strips, or other power
connection points with too many plugs.
foreignobjects,liquidspillage
-To avoid personal injury caused by fire or electrical shock
from contact with internal high voltage points, never insert a metal object into the product. Avoid
using the product where there is a danger of spillage.
heat
-Never use or store this product near any heat source such as a radiator heat register,
stove, or any type of equipment or appliance that generates heat, including stereo amplifiers.
servicing
- Refer all servicing to qualified personnel. Attempting to remove the covers or
disassemble the product, could expose you to dangerous high voltage points.
damagerequiringservice
- If you notice any of the conditions described below while
using a specified AC adapter unplug it from the wall outlet and refer servicing to qualified
service personnel:
1. Liquid has been spilled onto the product or some other object has fallen into the product.
2. The product has been exposed to water.
3. The product does not operate normally despite following operating instructions. Adjust only
the controls described in the operating instructions as improper adjustment of other controls
could damage the product and require extensive repair word by a qualified technician.
4. The product has been dropped or damaged in any way.
5. The product exhibits distinct change in performance.
replacementParts
-When replacement parts are required, make sure that the authorized
service centre uses only parts with the same characteristics as the originals, as recommended
by the manufacturer. Unauthorized substitution of parts could result in fire, electrical shock, or
create other hazards.
safetyCheck
-Upon completion of servicing or repairs, ask the service technician to perform
safety checks to determine that the product is in good working order.
Apparatus shall not be exposed to dripping or splashing and no objects filled with liquids, such
as vases, shall be placed on or next to the apparatus.
Wherethemainsplugorall
-pole mains switch is used as the disconnect device, the
disconnect device shall remain readily operable.
Remote control transmits a directional infrared beam. Ensure to aim the remote control directly
at the infrared sensor of the unit during operation. If the sensor has been covered or there is a
large object between the RCU and sensor or it is exposed to direct sunlight or a strong artificial
light (fluorescent or strobe light) the sensor may not be able to receive the remote signal. In this
case, change the direction of the light or reposition the unit.
1.2storage
Your receiver and its accessories are stored and delivered in a packaging designed to protect
against electric shocks and moisture. When unpacking it, make sure that all the parts are
included and keep the packaging away from children.
When transporting the receiver from one place to another or if you are returning it under
warranty make sure to repack the receiver in its original packaging with its accessories. Failing
to comply with such packaging procedures could void your warranty.
