H‐HDMI‐CC‐RF
Chapter 2 Installation Guide
Please use caution when operating this device in order to abstain from any possible injury
during installation. For this reason, please read all details listed below and make and use
caution before proceeding to operate and use this electronic equipment.
2.1
Safety
Instructions
Must be operated and maintained in an area free of dust and debris.
The cover should be securely fastened, do not open the cover of the chassis when the power is on. This
will also void Thor’s manufacturer’s warranty.
After installation, securely stow away all loose cables, external antenna, and others.
Be careful when connecting a power source to the device.
Do not operate in wet or damp areas. Make sure the extension cable is in good condition
Make sure the power switch is off before you start to install the device
Avoid placing the device next to central heating components and in areas of high humidity.
Do not cover the device with anything that obstructs the ventilation slots.
If the network encoder has been kept in cold conditions for a long time, keep it in a warm room
minimum 2 hours before plugging into the mains.
Mount the device in vertical position with the connectors located on the top side.
When replacement parts are required, be sure the service technician has used replacement parts
specified by Thor Broadcast. Unauthorized substitutes may result in fire, electric shock or
severe malfunction which will not be covered by Thor’s Warranty.
