Thor Kitchen TRF3602, Use And Care Manual

MAINTENANCE AND CARE OF THE REFRIGERATOR

4.1 Overall cleaning

4.2 Overall cleaning

Dusts behind the refrigerator and on the ground shall be timely cleaned to improve the cooling effect and

energy saving.

Check the door gasket regularly to make sure there are no debris. Clean the door gasket with a soft cloth

dampened with soapy water or diluted detergent.

The interior of the refrigerator should be cleaned regularly to avoid odor.

Please turn off the power before cleaning interior, remove all foods, drinks ,shelves, drawers, etc.

Use a soft cloth or sponge to clean the inside of the refrigerator, with two tablespoons of baking soda and

a quart of warm water. Then rinse with water and wipe clean. After cleaning, open the door and let it dry

naturally before turning on the power.

For areas that are difficult to clean in the refrigerator (such as narrow sandwiches, gaps or corners), it is

recommended to wipe them regularly with a soft rag, soft brush, etc. and when necessary, combined 

with some auxiliary tools (such as thin sticks) to ensure no contaminants or bacterials accumulation in 

these areas.

Do not use soap, detergent, scrub powder, spray cleaner, etc., as these may cause odors in the interior of

the refrigerator or contaminated food.

Clean the bottle frame, shelves and drawers with a soft cloth dampened with soapy water or diluted

detergent. Dry with a soft cloth or dry naturally.

Wipe the outer surface of the refrigerator with a soft cloth dampened with soapy water, detergent,etc., 

and then wipe dry.

Do not use hard brushes, clean steel balls, wire brushes, abrasives

(such as toothpastes), organic solvents (such as alcohol, acetone,

banana oil, etc.), boiling water, acid or alkaline items, which may

damage the fridge surface and interior. Boiling water and organic

solvents such as benzene may deform or damage plastic parts.

Do not rinse directly with water or other liquids during cleaning to

avoid short circuits or affect electrical insulation after immersion.

According to the direction arrow in the figure below, use both hands to squeeze the tray, and push it 

upward, then you can take it out.

After washing the tray having been taken out, you can adjust its installing height in accordance with your 

requirement.

(The picture above is only for reference. The actual configuration will depend on

the physical product or statement by the distributor.)

15