Basement creation. After the floor has been cut, an arbitrary basement for
the model can be created. The
Count of sides
parameter specifies the number
of faces in a generated basement, and
Height and Radius
parameters specify
the corresponding height and radius of the basement in millimeters.
Floor detection. The procedure automatically recognizes and cuts the floor
surface. Cut height is counted from the floor and is specified according to
how the model has been scanned. When the Thor3D rotary table is used the
parameter of 150 mm should be set, when scanning is executed without this
table the value of 5 mm should be set.
40
Software manual
40
Summary of Contents for Calibry
