Page 12
20381-D02
Single- and Dual-Axis Scanning Galvo Systems for Large Beam Diameters
Steps (1) to (3) are applicable only if using the Thorlabs GPS011 PSU.
1) Ensure the correct voltage range is selected on the PSU - see vc
2) The circular 3-pin connector on the power output cable and the OUTPUT socket
on the PSU are fitted with alignment key ways to ensure connection in the correct
Caution
This section is applicable only to driver card units, with a PCB at rev 11 or later.
For details on connecting earlier units, please see Appendix B.
PCB revisions can be identified as follows:
Up to and including issue 10
Issue 11 onwards
Summary of Contents for GVS011
Page 40: ...www thorlabs com ...