LFE1220-US, -EU, and -UK Laminar Flow Enclosures
Chapter 3: Installation
Page 24
ETN055682-D02
3.6. Roof Fitting
3.6.1. Required Parts:
Code
Description
Qty
I
Roof Panel - Inner
2
J
Roof Panel - Outer
2
AG
Barrel Plug
20
AH
Push Rivet
40
Tools Required
AL
4 mm T-handle hex driver
3.6.2. Roof Panel fitting
25. Peel back the protective plastic film from Roof Panels (I and J) just enough so that the fixing holes can be
accessed.
IMPORTANT
The Roof Panels (I and J) are protected by plastic film on both sides. For maximum protection during the assembly of
the enclosure, it is recommended to only partially remove the film; enough so that the fixing holes can be accessed, as
indicated by the dashed line in the picture below.
Figure 22 Peeling Back the Protective Film
Summary of Contents for LFE1220-EU
Page 60: ...www thorlabs com ...