GPX3800 and GPX3850 Glass Processors
Chapter 6: Added Capabilities of GPX3800 / GPX3850
Page 50
TTN047534-D02
FHB Offset (mm):
The position offset applied to both fiber holding blocks when in
Cleave View
. A negative offset
will move both fiber holding blocks to the left, a positive offset will move both fiber holding blocks to the right.
Together with the furnace motor position, this makes it possible to view the cleave operation through the imaging
system.
Figure 27
GPX Cleaver View Properties
6.1.3. GPX Cleave Exposure
GpxCleaveExposure
works in the same way as regular side view exposure. This process provides the correct
amount of illumination to be able to view the cleave process. The GPX Cleave Exposure Properties window is
identical to that of any regular side view exposure properties.
Figure 28
GPX Cleaver Exposure Properties
6.1.4. GPX Cleaver Focus
GPXCleaveFocus uses a focus measurement call that will determine which edge of the fiber is visible and the
user then determines the optimal focus.