KATflow 150
3 Installation
Press the sensors firmly onto the pipe. There should be no air pockets
between the transducer surface and the pipe wall.
Using a measuring tape, adjust the sensor separation distance as sugges-
ted by the flowmeter. When the sensor positioning screen (Section 3.3) is
displayed, the middle bar allows fine adjustment of the sensor location.
Ensure that the narrower side of the clip is above and inside the wider side
and that the two sides of the clip do not come into contact while tightening,
as this will prevent the strap from being correctly tensioned.
19
Illustration 10: Sensor mounting with tension straps and clamps
Illustration 11: Clip arrangement for correct tensioning
