KATflow 150
4 Operation
Select transducer configuration (number of
passes) using cursor keys.
Auto
Automatically
1
1 pass, diagonal mode
2
2 passes, reflection mode
3
3 passes, diagonal mode
4
4 passes, reflection mode..etc.
Confirm by pressing <
ENTER
>.
Use cursor keys to select
Start Measurement
.
Confirm by pressing <
ENTER
>.
Sensor placement screen: Mount transducers
with suggested spacing and use middle bar for
fine adjustment of position (central position is
desired). Observe signal-to-noise (upper bar)
and quality (lower bar). These should be of
identical length.
Confirm by pressing <
ENTER
> to obtain meas-
urements.
Success!
4.4
Measurements
4.4.1
Main process value (PV) display
Measurement is started using the Quick Setup Wizard. Once all the parameters are
programmed, any subsequent power-on sequences will bring up the main PV dis-
play immediately.
Display screen
Operation
The main process value can be changed
using the menu structure.
Press
<ESC>
at any time to access the
main menu.
Change to other display modes by press-
ing
<DISP>
or
<NEXT>.
25
Measurement
screens
Table 5: Quick setup wizard
