KATflow 150
5 Commissioning
Error
Defines output behaviour in the event of error
Select from list ↑↓
Pulse Out
Source
Select from list ↑↓
Units
Select from unit list ↑↓
Mode
Select from list ↑↓
Alarm (select on point, off point)
Pulse (select value, width)
Linear (select min value, max value, damping)
Relay Out
Source
Select from list ↑↓
Units
Select from unit list ↑↓
Mode
Select from list ↑↓
Alarm (select on point, off point)
Pulse (select value, width)
Linear (select min value, max value, damping)
PT100 4 WIRE
Source
Select from list ↑↓
Type
Select from list ↑↓
User (Fixed value - enter)
PT100 (Measured - select whether inlet, outlet,
compensation and enter offset if required)
Current In
Source
(channel)
Select from list ↑↓
Off, Channel 1, Channel 2, Math 1, Math 2
System, Test
Source
(value)
Select from list ↑↓
Density, Viscosity, Temperature, Other
Minimum, Maximum, Span settings as on outputs
RS 485
[where specified]
Modbus RTU
[where specified]
HART®
[where specified]
Other In/Out
types
Refer to Technical Support
System
Instrument
info
Model Code
KF150
Serial No.
Example:
15002013
HW Revision
Example:
2.0, 1.5
SW Revision
Example:
3.1, 2.4
Calculation
Select channel
Channel 1, Channel 2
Low F Cut
± Low flow velocity cut off
0 ... 0.025 m/s
Max F Cut
± Maximum flow velocity cut off
0 ... 30 m/s
Corrected
Apply flow velocity profile correction
Yes
No
PV Offset
Calibration process variable zero offset
-30 ... 30 m/s
PV Scaling
Calibration process variable gradient scaling
0.001... 10 units (based on flow velocity)
31
