KATflow 150
3 Installation
3
Installation
3.1
Unpacking and storage
3.1.1
Unpacking
Care should be taken when opening the box containing the flowmeter, any mark-
ings or warnings shown on the packaging should be observed prior to opening. The
following steps should then be taken:
Unpack the flowmeter in a dry area.
The flowmeter should be handled with care and not left in an area where it
could be subject to physical shocks.
If using a knife to remove packaging care should be taken not to damage
the flowmeter or cables.
The flowmeter package and contents should be checked against the deliv-
ery note supplied and any missing items reported immediately.
The flowmeter package and contents should be checked for signs of dam-
age during transport and any problems reported immediately.
The vendor accepts no responsibility for damage or injury caused during
the unpacking of the instrumentation supplied.
Excess packing materials should be either recycled or disposed of in a suit-
able way.
3.1.2
Storage
If storage is necessary, the flowmeter and sensors should be stored:
in a secure location,
away from water and harsh environmental conditions,
in such a way as to avoid damage,
small items should be kept together in the bags provided to avoid loss.
3.1.3
Identification of components
The following items are typically supplied (please refer to your delivery note for a
detailed description):
KATflow 150 ultrasonic flowmeter
Clamp-on sensors (one pair for single channel operation, two pairs for dual
channel operation)
Sensor connection cable(s) if not direct sensor connection
Sensor mounting accessories
Coupling component
Operating instructions
Project and/or hazardous area documentation (optional)
Calibration certificate(s) (optional)
Temperature measurement probes (optional)
9
