Installation Instructions
Roxtec CRL 4" and 5"
Installation
Insert the frame into the sleeve
opening.
Lubricate the frame sparsely on
the outside black rubber part with
Roxtec Assembly Gel.
Lubricate the inside faces of the
frame thoroughly, especially into
the corners.
Lubricate all modules for the frame
thoroughly, both the inside and the
outside surfaces.
Achieve a 0.1-1.0 mm gap between
the two halves when held against
the cable/pipe.
Adapt modules which are to hold
cables or pipes by peeling off
layers until you reach the gap seen
in pic. 5b.
Insert the modules in the frame.
Push the front fittings back towards
the centre.
Tighten the nuts.
Max torque is 4 Nm/2.95 lbf·ft.
Loosen the nuts and push the front
fittings to the sides.
The installation is complete.
Excess Roxtec Lubricant will
protrude when tightening the seal.
Approx. 8 mm/0.315"
