This document is the property of EADS Secure Networks Oy
and should not be copied or circulated without permission.
6
4.2
To install the safety plug
Figure 3
1
1
2
1)
Make sure that the hatches
(1) on both sides of the
safety plug are out and the
slot is in the horizontal
position (2).
2)
Insert the safety plug
Figure 4
4
3
3)
Lock the safety plug in
place by turning the slot
(e.g.with a coin) to the
vertical position (4). The
safety plug is properly
installed when the slot is in
the vertical position and the
hatches are closed (inside
the safety plug).
To remove the safety plug, open it by turning the slot to the
horizontal position (3). This opens the hatches on both sides of the
safety plug. You can now remove the plug.
5
FAULTS AND DAMAGE
If there is any reason to suspect that the safety of the unit has been
impaired, it must be withdrawn from use and removed immediately
from the Ex-area.
Summary of Contents for THR880i Ex
Page 1: ...THR880i Ex Safety Instructions...
Page 2: ......
