Initialise System Parameters
Initialise System Parameters
Initialise System Parameters
Initialise System Parameters
System Generation
System Generation
System Generation
System Generation
25-Jul-00
25-Jul-00
25-Jul-00
25-Jul-00
Page
Page
Page
Page 4-3
4-3
4-3
4-3
that you have been registered in the database for the Inmarsat-C
Network.
The Transceiver only uses the mobile number when sending
Message Position Reports (see the
Message Handling Software
Operators Guide
), to indicate which Transceiver originated the
position message.
4.2.2
Altering baudrate and protocol settings
The baudrate and protocol settings can be changed by the com-
mand :
: se -c
Console-status : 4800,N,8,1
Software handshake : no
:
: se -c ?
Enter parameters as baudrate,parity,databits,
stopbits > 4800,N,8,1
Software handshake Y/N > n
Factory settings is obtained by pressing the Stop button at power-
on.
Please notice that changing the baudrate or other protocol set-
tings in terminal mode only changes the transceiver configura-
tion. It is therefore necessary also to change the Message Termi-
nal serial port settings to the identical configuration otherwise the
system will not function properly.
On the Message Terminal this is done in the “Application - Sys-
tem — Option — Serial Ports” menu.
