Chapter 5: Using the web interface
TT 98-122274-Q
Setting up the interfaces
98
If you select
Enabled
, the Header information of each data packet will be compressed, leaving
more bandwidth for the actual data.
For further information, see Header compression on page 95.
4.
Select the source of the
APN
.
There are four options for setting the APN. Unless you have special requirements, it is
recommended to use the SIM default, or to set the common APN to SIM default, and then
select Common here. You have the following options:
•
Common.
The APN is taken from the Common settings defined under
SETTINGS > Common
. Refer to Setting a common APN on page 117.
•
SIM default
. The APN is taken from the SIM card.
•
Network assigned.
The APN is assigned from the network.
•
User defined
. Type in the APN. APNs are provided from the Airtime Provider.
5.
If your APN uses a password, type in the user name and password provided from the Airtime
Provider.
6.
Select the
Primary Profile
.
Select a Profile from the scroll list. This Profile is used by the USB interface as a first choice,
when possible.
There are 4 predefined Profiles: Standard, Streaming 32 kbps, Streaming 64 kbps and
Streaming 128 kbps. Additionally, you can define your own custom Profiles.
For further information on Profiles and Traffic Flow Templates, see Using Profiles on page 130
and Using a Traffic Flow Template on page 133.
7.
Select the
Secondary Profile
.
To select more than one secondary Profile, press and hold Ctrl while selecting.
The Context Identifiers (CIDs) for the selected primary and secondary Profiles are listed under
Profile CIDs
. You may need these CIDs when you create a dial-up connection. See Creating a
dial-up connection on page 71.
8.
Click
Apply
.
Important
If you have selected a Streaming connection as your Primary Profile, the USB
interface will be running a Streaming connection until you select another
Profile or disconnect the interface. However, if you select one or more
Secondary Profiles, you can set up your Traffic Flow Template so that it will only
use the Streaming Profile for certain types of traffic.
Note
If you have selected both a Primary and one or more Secondary Profiles you
must define a Traffic Flow Template before you can establish a valid
connection.
