K I O S K O P E R A T I O N S M A N U A L
5
Now that everything has been securely fastened and attached to the kiosk, you will need to connect
everything to the computer/USB hub, to power and then bring online. Utilizing the labels for devices and
hardware, begin connecting those devices to the computer and hub as follows:
1.
Connect the touchscreen monitor’s VGA cable (large plug with screws) from the back to the computer.
2.
After checking that the power supply cord is securely in place on the monitor and computer, proceed
to plug both into the power supply. Turn on and wait for computer to start up Windows and the kiosk
software.
3.
Reference Troubleshooting Guide on page 14, and use the opening section as a guide to get to the
desktop of your kiosk’s computer.
4.
On the desktop of computer, open the device manager as follows; to open device manager, click on
the Windows start button (lower left corner of screen) and then type device into the search bar at the
bottom. Once ‘Device Manager’ populates into the list, click on it.
At this point, you can now start connecting your devices to the computer and USB hub (if needed). Also
unplug any keyboard and mouse from the computer.
5.
Start with getting the Fujitsu Bill Dispenser USB cord plugged into a 2.0 USB port on the computer.
Then power on the dispenser.
Three Square Market will finish the installing process when registering
the kiosk.
6.
Next, get the MEI Coin Recycler’s USB cord and plug into a 2.0 USB port on the computer. Then power
on the coin recycler.
Three Square Market will finish the installing process when registering the kiosk.
7.
Using the MEI Bill Acceptor harness, plug the USB into a 2.0 USB port on the computer. Then power
on.
Three Square Market will finish the installing process when registering the kiosk.
8.
Take the credit card reader and plug the USB into a 2.0 USB port on the USB hub. It will show up in the
device manager as a generic communications (COM1) port.
9.
Take the monitor’s USB type A to B cord and connect the square shaped end into the back of the
monitor (behind the bracket that holds the computer), then into a 2.0 USB port on the USB hub.
10.
Locate the webcam at the top of the kiosk (in the center), and plug it into a 2.0 USB port on the
computer. Allow it to install itself, and then check device manager to ensure it properly installs.
Three
Square Market will ensure install process as a part of registering the kiosk.
11.
***If using a biometric scanner, follow this step
: simply plug into one of the computers or USB hub’s
2.0 USB ports and the drivers are automatically installed after you plug in the reader for the first
time.
Summary of Contents for Kiosk
