WWW.THOROUGHCLEAN.COM.AU
2.1 INITIAL SET-UP
Inspect shipment for damages during transit and unpack. Report any damages to your
transport company by writing details on delivery docket before signing..
Connection supply hose to water supply:
o
Use hose with minimum 20 mm inside diameter
O
Required minimum, of 10 PSI / 21 LPM (Litres per minute)
Turn on the water supply.
Remove the High Pressure Jet from the lance and run mains pressure through
the unit for 1 minutes be pressing the trigger on the gun/lance assembly to
remove any impurities in the system which may have been dislodged during initial
transport. Ensure the nozzle is unblocked.
o
NOW ONLY
refit the H.P. Jet
Last Checks:
o
Check oil levels in H.P. Pump & Slave Tank. Fill up with SAE 30 or SAE
15W40 if required.
o
Check fuel level - fill up if required using CLEAN & FRESH PETROL FUEL
o
Check engine air cleaner and water filter is in place, tight and unblocked
o
Ensure water supply is open and that there are no obvious water leaks
o
Visually check lance & gun assembly
Please read Safety Instructions and special Site Specific Instructions first.
2. INSTALLATION & SET UP
2.2 OPERATOR INSTRUCTIONS - Starting your engine
1.Unroll high pressure hose on reel ensure there are no kinks in it.
2. Starting Procedure:
O
Ensure the main ON/OFF switch (photo 2) is OFF
O
Ensure the Choke is ON (Move fully to the LEFT - ‘A’ in photo 1.)
O
Ensure the Fuel is open (Move ‘B’ fully to the RIGHT - Photo 1.)
Note:
There are picture diagrams on the engine showing which way is on and off.
O
Now take the recoil cord handle ‘D’ and give it 2 pulls to prime the engine.
O
Now switch the main ON/OFF switch (photo 2) to ON and pull the recoil cord
handle in a strong, even, fully extended pull. The engine should fire up.
O
As soon as it is running, turn the Choke OFF by pushing the Choke Lever ‘A’
all the way to the left.
Photo
Photo 2.
