THRUSH AIRCRAFT, INC – MODEL S2R-R1340
AIRCRAFT MAINTENANCE MANUAL
4-12
Effective: 01/01/2008
The mixture control requires
a control rod movement of
approximately 1-5/16 inches.
The control lever has a 75 to
80 degree radial travel.
E. Install access panels.
CLEANING FUEL STRAINER
The carburetor fuel strainer should be
removed and cleaned at periodic
intervals. To remove strainer, proceed
as follows:
A. Cut safety wire and remove strainer
from carburetor.
B. Wash strainer in approved solvent.
Clean strainer chamber of any
foreign material.
C. Reinstall strainer, tighten and safety
wire.
Figure 4-4: Carburetor and Air Induction
STARTER
A 28-volt dc, direct cranking electric
starter is mounted on the upper rear
section of the engine (see Figure 4-1).
When the starter is energized through
the starter relay, the starter jaw is
mechanically engaged with the engine
