6
USER GUIDE
For FrSky PPM receivers
From the Configuration tab, switch the Receiver Mode from RX_SERIAL to RX_PPM. Click save in the lower
right corner of Betaflight to adjust the configuration.
For FrSky SBUS receivers
The Riot is pre-configured for FrSky XSR/X4R, so this step is already done!
Bind the receiver to the radio & verify
the RX (receiver) channel mapping
Each type of radio operates differently. Refer to your radio instruction manual to bind the receiver to the
radio and to set the failsafe.
WARNING!
Remove props and disconnect battery before RX (receiver) verification.
Verify the Riot’s connection to the radio from the Receiver tab in Betaflight:
• Using Mode 2 controls, pitch forward and
throttle down. Watch the graph in Betaflight to
verify the channel mapping. The pitch bar graph
should move right as the throttle bar moves left.
3
pitch forward and throttle down
Summary of Contents for 250R PRO
