GAS SPRING INSTALLATION (cont)
Insert the base end mount of the black gas spring in to the slot in
the aluminum mount block which is attached to the cross brace
of the front legs. Do this by pulling outward on the white handled
spring pin, inserting the gas spring base end tab and then releasing
the white handled spring pin until it engages in the tab.
GAS SPRING INSTALLATION (cont)
Repeat previous step on the operating end of black gas spring
where it attaches to the abdominal cushion. You may need to
pull up or push down slightly on the abdominal cushion by
grasping the aluminum mount block to help with alignment so
that the engaging spring pin slides in easily.
GAS SPRING INSTALLATION
GAS SPRING & CONTROL LEVER REMOVAL
Remove the abdominal swing-away gas spring and control lever
from its storage location. Note that the control lever is positioned
and attached by a magnetic latch.
Slide the black control lever housing onto the front folding leg
support brace and position it to come into contact with the black
poly lock. It will be held in place with an internal magnet.
The abdominal swing-away section is now installed. Tip the table upright.
Abdominal Swing-Away Section: Set-Up (follows pg 9)
