Thulos TH-PV3000, Instruction Manual

Steam Ironing

1. 

Fill water in the iron as per the water-filling methods.

2. 

Plug the appliance in the socket.

3. 

If only set thermostat dial to MAX position as per the temperature indicator, steam iron will be available, 

otherwise water may leak from the soleplate.

4. 

It indicates that the temperature has been ready until the indicator light goes off.

5. 

Set the steam regulator correctly, increase the steam output by rotating the steam regulator anticlockwise, 

otherwise decrease.

Caution: Synthetic Fabric, Nylon, Synthetic Silk and Silk cannot use the steam iron, otherwise it will damage 

the finish of surface.

Burst of Steam

This function will be able to provide more steam to remove stubborn creases.

1. 

Set the thermostat dial button to MAX until the indicator light goes off.

2. 

Release the steam by pressing the steam button.

3. 

Wait for several minutes and let the steam penetrate through the fabric, and then release more steam 

through pressing this buttons again.

Note:

1. There should be 3-5 seconds rest between two times of pressing Steam Button in order to obtain the best 

steaming result.

2. Fill the water to the Max position before using this function.

3. In order to prevent the water leaking from soleplate, please do not press the steam button continuously with 

more than 5 seconds.

Spraying Methods

1. 

Fill the water in the iron as per water-filling methods.

2. 

Press water spray button.

Note: No matter what steam ironing or dry ironing is, Spray will always be available in any case.

Self-cleaning

In order to remove scale and impurities, apply self-clean system once every month at least.

1. 

Fill half of the box with box. Set the steam knob to No Steam position.

2. 

Plug in the iron to the socket. Set the thermostat knob dial to Max.

3. 

When the pilot light goes off, i.e. the steam iron has been in its presetting temperature.

4. 

Unplug the iron, and hold the appliance horizontally over a sink.

5. 

Set the steam knob to position “Self-Clean”, boiling water and steam will come out from the soleplate, 

shake the iron slightly in order to wash out impurities & scale.

6. 

Set the steam knob to position O when no water in the box.

7. 

Stand the iron on its end and plug the appliance in the socket, heat up the iron again.

8. 

Move the iron over a piece of clean cotton cloth, and the remaining water in the iron will evaporate from 

the soleplate.

Anti Calc

With a small filter built-in,which can make hard water soft, thus preventing any calc or flake accumulated on the 

surface of soleplate,this features can prolong the life of the iron for long use.