USERS MANUAL AURORA SERIES
DONGGUAN THUNDER LASER EQUIPMENT CO.,LTD
Shatian Town, Shatian Dadao, Mintian
Tel :(86)769 826653
Dongguan City, Guangdong Province, China
20
Chapter4. Machine view
1. Left side door
On fiber laser, there are installed Z motor and Driver, Z limit switches.
Please open this door for checking these parts, but must pay attention to the electric current.
2. Exhaust hole
This is for exhaust the fume.
3. Flap protection sensor
This is where open flat protection exist.
Laser will stop working once the cover is
opened during working.
4. Light switch
Turn on the LED lamp inside the fiber laser.
5. Up button
You can raise the field lens up.
6. Down button
You can lower the field lens.
7. Auto focus button
The fiber laser will adjust the focus length
automatically.
8. Start button
Start to marking job.
9. Emergency stop button
Once there’s an accident happen during working, please turn off this switch immediately. It will be cut off
the laser power and motion power immediately.
10. Rotary connector
To connect rotary device.
11. Field lens
You can replace the Field lens by rotate it.
12. Galvanometer
Composed of two parts: optical scanning device and servo control.
13. Indicates light
If fiber laser machine is running a job, the signal lamp is in red light.
If laser machine is not at work, the signal lamp is in green light.
