USERS MANUAL AURORA SERIES
DONGGUAN THUNDER LASER EQUIPMENT CO.,LTD
Shatian Town, Shatian Dadao, Mintian
Tel :(86)769 826653
Dongguan City, Guangdong Province, China
15
Chapter3. PROcess of Installing
3.1 Unpacking
You receive your THUNDER LASER AURORA SERIES packed in a wooden box which contains the
laser machine and additional accessories. The following steps give you an overview of the unpacking
and assembly of the laser. Please follow these steps carefully.
Keep the packing box. You will require it in case of a return.
Dispose all waste according to the applicable waste disposal law.
1. Put the wooden box on a flat and spacious room for unpacking.
2. Remove the machine box; carefully remove the protective foam, wraps, films, etc.
3. Please keep the warranty certificate as well as the model and serial number of the machine. If you
need tech support we may ask you for this information.
4. Then start to install the machine, carefully following the instructions in this manual.
3.2 Location
Before you install the fiber laser system, you should select an appropriate location. Follow the guidelines
shown below:
1. Avoid locations where the system is exposed to high temperatures, dust and high
humidity. (The humidity must not exceed 70% and the temperature must not be close to the
dew point.)
2. Avoid locations, where the system is exposed to mechanical shocks.
1. Circuit Breaker protection: Do not connect other devices on the same circuit as the laser
system. It requires a dedicated circuit.
2. DO NOT open any of the machine’s access panels while the unit is plugged in. Opening a
panel may expose the operator to severe electric shock, invisible laser radiation, mechanical
pinch points, burns, blindness, and other hazards. ALWAYS POWER OFF AND UNPLUG!
3. DO NOT make or break any electrical connections to the system while the unit is turned on
