USERS MANUAL AURORA SERIES
DONGGUAN THUNDER LASER EQUIPMENT CO.,LTD
Shatian Town, Shatian Dadao, Mintian
Tel :(86)769 826653
Dongguan City, Guangdong Province, China
16
1. Avoid locations with poor air circulation; select a location close to ventilation (if
available).Select a location, whose room temperature is between 15 °C and 25°C (59° – 77°
F).
2. This is fundamental to maintain consistent and reliable operation of a fiber laser and the
machine itself. Avoid higher ambient temperatures and strong exposure of the engraver to the
sun. Use blinds, if required.
3. Mechanical shock and vibration of the laser will have detrimental effects on the performance
and life expectancy of the machine. It will manifest (over a period of time) with a noticeable
decrease in performance and increased maintenance required, possibly even damage. Setting
your Thunder Fiber Laser up in s suitable temperature controlled, dust free, moisture free,
level, stable surface (a level concrete floor) with the recommended extraction is critical to the
ongoing performance of the machine. It is also a warranty condition.
3.3 Connections
Perform the connections exactly in the order described; otherwise electrostatic charging
can damage your computer and/or the electronics of the laser system.
3.3.1 Connecting the Mains
Connect one end of the mains cable with the connection socket at the rear side of the laser device (see
Figure below) and the other end with a protected power outlet.
Mains voltage and operating voltage must correspond (AC 230V 50/60 Hz or AC 115V 50/60 Hz) – see
information label beside the connection socket.
Under no circumstances should you switch on the device if the voltages do not correspond.
